The E&P Hydraulics Motorhome levelling system allows your Motorhome to be level and stable in under two minutes. With the new touch panel the system has never been easier to operate either in the holder or while hand held. The system can also be used manually with one side of the van being rasied allowing your wheel locks to be fitted and secured easily or to keep the tyres off the floor over winter.
For details on fitting please fill out the form at the bottom of the page
The E&P Hydraulics full levelling system allows your vehicle to be level and stable in under two minutes. With a wide range of systems we can create a custom install for your commercial vehicle. Systems are from 2T to 10T with a large range of legs and brakets available.
For details on fitting please fill out the form at the bottom of the page
The E&P Touch panel comes standard with all full E&P Caravan systems from A&E Leisure. With all controls usable while in the charging station or removed its E&P most versatile panel ever. Also fitted on the charging station are additional level and retract buttons so you never need to worry.
For details on fitting please fill out the form at the bottom of the page
This is a mutual decision made between the customer and E&P Service Technician and it usually depends on the vehicle layout. Ideally it would be located in a storage locker inside the motorhome where it is safe and secure from any tampering and/or impact damage. If there is no feasible place to install within the vehicle, there is usually the possibility of mounting the pump underneath using the custom E&P Housing. The control panel positioning is also reliant on the vehicle layout and is again agreed between the E&P Technician and the customer. It is usually just inside an entrance for easy access..
Yes, this is useful for protecting tyres during long periods of storage, but it will not completely stop tyre degradation. It also provides extra security against theft. However, please ensure the exposed cylinders on the jacks are suitably protected from the elements, to prevent corrosion. This can be done with silicon spray, or by wrapping the hydraulic jacks with a cloth material.
Yes, a massive benefit to the E&P Hydraulics levelling system is that it aids with lifting the vehicle, to change the wheels & tyres quickly and easily. However it is the user’s responsibility to ensure the vehicle is safe to lift and that it is adequately supported with axle stands if any work is being carried out under the vehicle. Please do NOT work under a vehicle if the only method of support is the E&P Levelsystem.
No, it is a closed loop hydraulic system.
Yes, this is useful for protecting tyres during long periods of storage, but it will not completely stop tyre degradation. It can also help prevent a sticking handbrake and make the caravan more secure against theft. If you are leaving the system deployed for a long period, please use a silicon-based protective spray on the axle jacks, to prolong their durability.
Yes, this aids the fit of wheel security devices greatly. However you, the user, are responsible for ensuring the caravan is safe to lift and that it is adequately supported with axle stands if any work is being carried out under the caravan. Please do NOT work under a caravan if the only method of support is the E&P Levelsystem.
On average it can take between 12 and 16 hours to install an E&P Hydraulics Motorhome Levelsystem to our exacting standards. You would therefore be required to leave your motorhome with the dealer for 2 working days.